| Printer dimensions |
42cm (width) * 62cm (height with filament holder) |
| Weight |
8.2kg |
| Print volume |
200mm effective print plate diameter, 200mm maximum build height (truncated into shallow cone on top) |
| Print speed |
Up to 800mm/s move speed, up to 400mm/s print speed, 20 000mm2/s acceleration |
| Print materials |
1.75mm filament, PLA, ABS, PETG, PCTG, PP, PA, all common 3D printing thermoplastics with max extrusion temperature of 300C.Abrasive materials require hardened nozzle (V6 volcano type) |
| Frame |
16mm diameter AISI 304 Stainless steel tubes, PETG printed parts |
| Linear rails |
20x20mm anodised aluminum square sections |
| Arm carriages |
CFRP composite tube with PA12CF15 parts, self-lubricating IGUS bearing pads & seats |
| Arm rods |
Unidirectional CFRP composite tubes with 12mm POM bearing ball ends |
| Effector |
CFRP composite tubes with PA12CF15 corner nodes, self-lubricating IGUS bearing seats |
| Belts |
6mm fiberglass reinforced GT2 belts |
| Motors |
NEMA17 60cm 1.8deg |
| Extruder |
Ball-joint mounted dual drive geared remote extruder, 28cm Capricorn XS bowden tube |
| PSU |
Meanwell 350W 24V PSU |
| Heatbed |
24V PCB heatbed, magnetic spring steel PEI buildplate |
| Hotend |
V6 threaded heatsink, bi-metall heatbreak, volcano heatblock & 0.4mm nozzle (max 300C extrusion temperature) |
| Part cooling |
2x4010 radial fans |
| Board |
BTT SKR Mini E3 V2/V3 |
| Firmware |
Klipper running on built-in RPI, Mainsail control interface served over Wifi |
| Screen |
4.3inch touchscreen display, klipperscreen |
